Integrated Fuel / Engine Indicator (IFEI) ¶ FLAP switch HALF or FULL settings and airspeed over 250 knots, abnormal flapĬondition (any flap is off or lacks hydraulic pressure), in spin recovery mode, or GAIN FLAP switch at FULL setting and airspeed below 250 knots. FLAP switch at HALF setting and airspeed below 250 knots. A green light indicates the aircraft is within flight parameters for the flight controlĬomputer to adjust flap scheduling in accordance with the selected switch position. The lights indicate that the gear is down and locked, or that a gear link is not locked.įlap Indications. There are three green landing gear position lights marked NOSE, LEFTĪnd RIGHT. Weapon delivery modes for weapon selection. The station jettison select buttons are also used in the backup A/G Pressing a button illuminates an internal light and selects a The buttons are labeled CTR (center), LI (left inboard), RI (right inboard), LO (left The station jettison select buttons are on the left edge of the instrument panel below the emergency With the landing gear up and locked with the master arm switch in ARM and jettisons the stores in a MSL or L FUS MSL and pressing the JETT center pushbutton. Jettison knob can jettison the right or left fuselage Sparrow or AMRAAM missile by selecting R FUS, After station and store/launcher/rack selection, jettison is performedīy pressing the JETT center pushbutton in the selective jettison knob. Jettison of either the stores or the stores and launchers/racks on the weapon stations selected by the The selective jettison knob is used to select Select which weapon station or stations will be jettisoned. The station jettison select buttons are used to Selective jettison is performed by the selective jettison knob inĬonjunction with the station jettison select buttons. The bottom two provide landing gear and flaps status. This panel has three primary functions the top is used to selectively select stations to jettison and Selective Jettison / Landing Gear, and Flap Position Lights Panel ¶ Holding the button down for 375 msec initiates jettison. The emergency jettison button, labeled EMERG JETT jettisons stores from the parent bomb racks onĮxternal stores stations 2, 3, 5, 7 and 8. Released when this switch is set to the ARM position. This switch controls the ability for weapons to be employed or jettisoned. Selected master mode to the mission computer. The selection is performed by the Stores Management Set (SMS), and the SMS identifies the The A/G master mode is selected by pressing the A/G master modeīutton. The A/A master mode is enteredĮither by pressing the A/A master mode button or by selecting an A/A weapon with the A/A weapon Landing gear is lowered, when the SPIN mode activates, or when the aircraft has weight on wheelsĪnd the throttle position (power lever angle) is greater than 56°. Power is applied to the aircraft, when the air-to-air or air-to-ground modes are deselected, when the The navigation master mode is entered automatically when The controls, displays, and the avionic equipment operation are tailored as aįunction of the master mode you select. There are three master modes of operation: navigation (NAV), air-to-air (A/A), andĪir-to-ground (A/G). These two buttons allow you to change between Air-to-Air (A/A) 1 and Air-to-Ground (A/G) 2 This knob varies the contrast between symbology and the dark background on any level of Rotate clockwise to increase brightness andĬounterclockwise to decrease brightness. This knob varies the intensity of the symbols and text. Placing the knob to NIGHT providesĪ lower brightness control range, and the DAY setting provides a brighter default setting. Placing this rotary knob to OFF prevents the DDI from operating. Side, and then each PB button is numbered sequentially in a clockwise manner. Select the function and the mode for proper indicator display. There are 20 pushbuttons (PB) on the DDI which are used to The left DDI is a 3-color (green, yellow, and red) display that provides desired information to control Left Instrument Panel Left Digital Display Indicator (DDI) ¶ F/A-18C Cockpit Overview Left Instrument Panel ¶įigure 8. Pressing LAlt+ C toggles mouse control between interacting with the cockpit and controlling yourįigure 7. Use this mission to explore the cockpit andīecome familiar with its layout. Hornet Instant Action Mission: Hornet Cold and Dark. In later sections of this guide, we will reference these locations. To help locate items more easily, we have broken the Hornet cockpit into eight primaryĪreas. Once in the cockpit, it’s best to have a general understanding of where the various controls are Standby Attitude Reference Indicator (SARI) Left Engine Fire Warning/Extinguisher LightsĪdvanced Multipurpose Color Display (AMPCD) Integrated Fuel / Engine Indicator (IFEI) Selective Jettison / Landing Gear, and Flap Position Lights Panel
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |